The IS 1566:1982 standard delineates the specifications for hard-drawn steel wire fabric utilized as reinforcement in concrete structures. It details requirements regarding dimensions, mechanical characteristics, fabrication processes, testing protocols, and marking for both square and oblong mesh configurations. This standard is crucial for manufacturers, suppliers, and engineers to guarantee product quality and compliance in reinforced concrete applications.
Overview
The IS 1566:1982 standard delineates the specifications for hard-drawn steel wire fabric utilized as reinforcement in concrete structures. It details requirements regarding dimensions, mechanical characteristics, fabrication processes, testing protocols, and marking for both square and oblong mesh configurations. This standard is crucial for manufacturers, suppliers, and engineers to guarantee product quality and compliance in reinforced concrete applications.
Audience
Contents
Structure
Frequently Asked
IS 1566 details specific square and oblong mesh dimensions along with corresponding wire diameters and nominal weights per square meter. Key mesh pitches include 25 mm, 40 mm, and 75 mm, paired with wire thicknesses ranging typically from 2.5 mm to 5.0 mm. The nominal mass per square meter varies accordingly, assisting in weight estimation and design planning. This classification facilitates selection based on structural demands and ordering reference numbers.
The standard mandates several mechanical evaluations: tensile tests across welded joints as per IS 1521-1972 to verify weld strength and wire tensile properties; bend tests on wire segments between welds conforming to IS 1716-1971 without prior heat treatment; and, where requested, certification that welded intersections can bear shear loads at least one quarter of the proof stress load of the smaller intersecting wire. These tests ensure mesh durability and compliance.
IS 1566 stipulates that the center-to-center spacing of wires (mesh pitch) must not deviate by more than ±7%, while mesh size variation should remain within ±5%. Sheet dimensions have tolerances of ±25 mm for lengths up to 5 meters, and ±0.5% for lengths exceeding 5 meters. The primary dimension refers to the length of main wires. These limits ensure consistent mesh quality and accurate panel sizing.
According to IS 1566, joints must be made using electric butt welding with welds staggered. Welds should endure a shear load at least 25% of the proof tensile load of the smaller intersecting wire, ensuring joint reliability. The wire used must be hard-drawn steel compliant with IS 432 (Part II) and suitable for welding, with certificates available upon request. Tensile testing of welded areas as specified by IS 1521 confirms joint performance.
Traceability is ensured by marking all ingots, billets, wires, and fabric bundles to link finished products back to their original castings. Manufacturers maintain identification of test specimens corresponding to material batches, allowing quality tracking. Upon purchaser request, certificates confirming conformity to IS 1566—including weld shear strength criteria—are provided. This systematic marking and certification process assures product accountability and compliance.
Ask AI about any clause, requirement, or provision in IS 1566. Get instant, clause-cited responses powered by our indexed library.
Free tier includes 150 queries (50 AI + 100 Reference) · No credit card required